 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |  |  |  |  |  |
The Bend-it is a bender that was specifically designed to bend automotive exhaust and
tail pipes. These sizes are typically 1 ½” - 3.0” in outside diameter. The typical center
line radius that the Bend-It utilizes is 1.75D. The typical muffler shop manual bender
can only bend 2D before wrinkling or excessive marking occurs. A big advantage that
this tighter radius bending capability will provide is more flexibility with the routing of the
pipe. THE QUALITY OF THE BENDS THAT ARE PRODUCED IS
EXCEPTIONAL. The Bend-It also does an outstanding job bending stainless tubing.
The new control that was designed specifically for the Bend-It utilizes state of the art
electronics. It incorporates a self-diagnostic program to test practically every portion of
the machine.
There are approximately 1,000 preprogrammed part numbers available for purchase.
They are categorized by Walker’s part numbers. The machine is also programmable.
The control will accept Bend Data Card format. The control also has a design mode
for copies existing pipes.
The operation of the machine is very easy to learn. A new operator should be able to
operate the bender with just a few hours of training. Optional tooling is available.
tail pipes. These sizes are typically 1 ½” - 3.0” in outside diameter. The typical center
line radius that the Bend-It utilizes is 1.75D. The typical muffler shop manual bender
can only bend 2D before wrinkling or excessive marking occurs. A big advantage that
this tighter radius bending capability will provide is more flexibility with the routing of the
pipe. THE QUALITY OF THE BENDS THAT ARE PRODUCED IS
EXCEPTIONAL. The Bend-It also does an outstanding job bending stainless tubing.
The new control that was designed specifically for the Bend-It utilizes state of the art
electronics. It incorporates a self-diagnostic program to test practically every portion of
the machine.
There are approximately 1,000 preprogrammed part numbers available for purchase.
They are categorized by Walker’s part numbers. The machine is also programmable.
The control will accept Bend Data Card format. The control also has a design mode
for copies existing pipes.
The operation of the machine is very easy to learn. A new operator should be able to
operate the bender with just a few hours of training. Optional tooling is available.
Quick Contact: 800-254-8665
